PIAGGIO NRG 50 User Manual

Water pump - overhaul
- Remove the pick-up/coolant inlet hose clamp
- Remove the transmission cover
- Remove the mixer
- Setup the special as shown in the picture
N.B.
WHEN SECURING THE TOOL, PAY ATTENTION NOT TO
OVERLOAD THE PLASTIC IMPELLER.
Specific tooling
020167Y Pump rotor immobiliser tool
- Remove the mixer/water pump drive-belt with the
two sprockets
- Remove the split ring from the shaft together with
the bearings
- Remove the steel washer
- Using the air heater, warm up the crankcase in
the area around the water pump bearings as
shown in the picture.
Cooling system NRG 50
COOL SYS - 220

PIAGGIO NRG 50 Specifications

General

Brand	PIAGGIO
Model	NRG 50
Category	Motorcycle
Language	English