System Programming
PIMA Electronic Systems 11
Chap. 3 System Programming
3.1 Menus and codes
FORCE has two separate menus, User and Technician, with two matching Master codes. In
addition, there are up to 144 user codes (FORCE Lite: up to 64). The Master user code allows
setting all the user menus. Other user codes can be restricted by permissions.
The Master technician code allows entering the Technician menu. Monitoring stations’ menus
can have lock codes. Refer to the technician.
3.1.1 Code setting guidelines
Note the following, when setting codes:
All codes are made of four to six digits, except the Quick Arm (two-digit) code.
Codes cannot start with the digits of other defined code, including the Quick Arm 2-digit
code. For example, a five-digit user code cannot start with the digits of a four-digit user
code.
Every code must be unique.
After saving a code, it can not be revealed or restored in any way.
The codes 1234 and 5555 are reserved.
3.1.2 How to enter the menu and change the default codes
To enter the FORCE menus for the first time, you must change the default Master user (5555)
code. This is usually done by the installer of the alarm system.
Do as follows to change the codes:
1. In the main screen, press 5555. The code changing screen
is displayed.
2. Press - the curser moves to the right.
3. Enter a new 4-6 digit Master code.
Write down the code and keep it in a safe place.
4. Press - the curser moves back to the left.
5. If only the Master code field is displayed, press to save and return to the main screen.
The new code has now been saved.
6. If the
Tech. Code
field is displayed, press the arrow down key, press and enter a new
4-6 digit Technician code. Write down the code and keep it in a safe place.
7. Press .
8. Press to save and return to the main screen. The new code has now been saved.
9. Set the system time - see section 9.4, on page 22.
11 May Sun 08:12
Master Code:--
Technician Code:--
Press to Exit
To Next Page
Loading...
Need help?
General
