Pima FORCE Series User Manual

Arming and Disarming
PIMA Electronic Systems 13
Chap. 4 Arming and Disarming
 You can find detailed information on the arming modes in the
Glossary, on page 29.
 From here onwards, in addition to the Master code you can use any
user code with permissions.
4.1 Arm Away
Arming Away is used when the premises is left vacant and all the detectors should be activated.
Check that the message “Ready to Arm” is displayed - if open zones are displayed, see Chap. 5,
on page 15; if faults are displayed, see section 9.1, on page 21.
1. Press and hold the key, until the keypad sounds a long beep; the alarm system is
immediately armed, while the Exit Delay
7
starts running, and the keypad sounds beeps
and displays a progress bar timer. During the delay, passing through delayed zones will
not trigger the alarm and will allow you to leave the premises.
2. If one key arming is not enabled (by the technician), you will have to enter a user code.
User Menu  Arming & Disarming  Arm Away
3. You can also arm via the menu: press , enter a User code  Arming & Disarming 
Arm Away .
The technician can set the siren to sound beeps, to indicate on arming and disarming.
4.2 Arm in Home 1-4
The Home 1-4 arming modes are used in defined parts of the premises - floors, separate
rooms, perimeter detectors, etc. - when it is partially occupied, or during night time. As the
alarm system is armed in one of these modes, only the Home mode zones (detectors) are
armed, while all the other zones are not; triggering an armed zone setts off the alarm, while
people can stay in the zones that are not armed at the same time.
The technician can define up to 4 Home modes.
1. To arm in Home 1 , press and hold the key, until the keypad sounds a long beep. To
arm in Home 1-4 , press and hold the 1-4 keys; the Home zones are immediately armed,
while the Exit Delay
7
starts running, and the keypad displays a progress bar timer. During
the delay you can stay in delayed zones, without setting off the alarm
7
. Entering an instant
zone will set off the alarm.
2. If One Key Arming is not enabled (by the technician), press and enter a user code.
User Menu  Arming & Disarming  Arm Home 1-4
3. You can also arm via the menu: press , enter a User code  Arming & Disarming 
Arm in Home 1-4 .
7
See the Glossary, on page 29.

Pima FORCE Series Specifications

General

Brand	Pima
Model	FORCE Series
Category	Security System
Language	English