FUEL SYSTEM Engine Control Linkage
2003 Pioneer 1200/1200SE Gasoline Vehicle Maintenance and Service Manual Page 14-5
14
NOTE: Make sure the intake hose is not twisted during installation.
21. Turn fuel shut-off valve (on fuel tank) to the ON position (Figure 14-21, Page 14-27 and Figure 14-22,
Page 14-28).
22. Connect the battery cables, positive (+) cable first, and tighten terminals to 20 ft-lb (27.1 N·m). Coat ter-
minals with Battery Terminal Protector Spray (CCI P/N 1014305).
23. Test drive the vehicle.
ENGINE CONTROL LINKAGE
See General Warning, Section 1, Page 1-1.
GENERAL INFORMATION
It is important that the accelerator pedal, governor linkage, and throttle adjustments are done correctly and in
the proper sequence. See following CAUTION.
Figure 14-3 Changing the Main Jet
Drain carburetor over
a catch basin by turning
bowl drain screw (11)
counterclockwise
2 to 3 turns.
STEPS 2 AND 3
STEP 4
A
Mark carburetor
and corresponding
position of fuel bowl.
B
Check for
coil located in
groove above
both ears.
Check for
spring seated
in recess of
float body.
If spring looks
like this...
or this...
then adjust
spring to look
like this by...
C
D
holding float firmly...and...
rotating valve counterclockwise
to seat spring in seat of float bowl.
CAUTION: DO NOT REMOVE VALVE/SPRING
FROM FLOAT. TO DO SO WILL DAMAGE SPRING.
1
2
3
4
5
7
8
6
9
11
12
10
To Next Page
Loading...
Need help?
General