30
En
04
Basic Picture Adjustment
4.2.7 Turn On the Sleep Timer
To save energy and to maximize the life of your flat panel display, try using the Sleep Timer for occasions when
the panel may be left on by accident. The Sleep Timer places the panel in Standby when the selected time elapses.
The Sleep Timer provides time periods of 30, 60, 90, or 120 minutes. When the Timer is down to five minutes, a
reminder appears on screen each minute until the time has elapsed.
To set the Sleep Timer, follow the steps below.
1 ) Press USER MENU.
2 ) Select
Sleep Timer
from the User Menu.
3 ) Select the desired time period.
Select between 30 minutes and two hours (120 minutes).
4 ) Press USER MENU again to exit the menu.
Note:
When the sleep timer has been set, “Remain ---min” appears at the top of the menu.
The Video Pattern timer has priority over the sleep timer. When the Video Pattern timer is on, the sleep timer
is deactivated. Video Pattern is explained in an earlier section in this manual.
PRO-141FD_PRO-101FD.book Page 30 Monday, May 12, 2008 3:27 PM
To Next Page
Loading...
Need help?
General
