50
En
Basic Playback
Playing Stereo Sources
The following instructions show you how to use the receiver for stereo audio or audio-visual.
1 For the VSX-859RDS set the slide switch
on the remote control to USE.
2 Turn on the RECEIVER.
3 Press the MULTI CONTROL buttons or the
FUNCTION button (or turn the MULTI JOG
dial) to select the source you want to
playback.
The FUNCTION button cycles through the sources in the
following order:
4 Press the STEREO/DIRECT button to select
the stereo mode.
The STEREO indicator lights on the display.
5 For the VSX-839RDS press RECEIVER.
This sets the remote to receiver control mode.
6 Press the SIGNAL SELECT button to select
the input signal. Set to AUTO.
(See “Switching Analog and Digital Signal Input” on page 51.)
7 Start playback of the component you
selected in step 3.
8 Adjust the volume by using the VOLUME
buttons on the remote control or the
MASTER VOLUME on the front panel.
If you are not able to get sound from the receiver the
problem may well lie with the SIGNAL SELECT button.
You need to make sure the input is set to the appropriate
ANALOG or DIGITAL setting. Refer to p. 51 for more on
this.
memo
S0URCE
DVD/LD TV/SAT VCR1 VCR2
CD
CD-R/
TAPE1
TUNER TVCONT
RECEIVER
USE SETUP
MULTI
OPERATION
CLASS MPX
DIRECT ACCESS
MULTI CONTROL
1
2
3
2
3
8
4
DIGITAL MULTI PROCESSING AMPLIFIER
REMOTE CONTROL UNIT
TV VOL
TV FUNC
MENU
ENTER
STEREO/
DIRECT
DSP
THXLIGHT
/DTS/MPEG
MUTE
TV
VOLUME
DISPLAY
RF ATT
TV CONTROL
FUNCTION
REMOTE SETUP
SYSTEM SETUP
INPUT
ATT
ADVANCED
MIDNIGHT
MULTI CH
INPUT
STANDARD
DIGITAL
NR
EFFECT/
CH SEL
SIGNAL
SELECT
0
DISC
++
––
+
–
+10
6
4
3
8
VSX-859RDS
VSX-839RDS
SOURCE
LOUDNESS
INPUT ATT DIGITAL NR FL DIMMER
REMOTE SETUP SYSTEM SETUP SIGNAL SELECT
TV VOL
TV
TVFUNK
To Next Page
Loading...
Need help?
General