54
En
Basic Playback
Adjusting Bass and Treble
You can use BASS +/– or TREBLE +/– buttons to adjust the low and high frequencies for each individual set of
speakers. If the receiver is in STEREO mode you can only adjust the FRONT speakers. In a surround mode
(STANDARD, ADVANCED THEATER, etc.) you can adjust the FRONT, CENTER, SURROUND and SURROUND
BACK speakers. The TONE button can also be used to bypass the tone circuitry (see #18, p. 23).
1 Press the TONE button on the front panel to
put the receiver in TONE ON mode.
2 Press the CHANNEL SELECT button on the
front panel to cycle through the different
tone adjust modes.
The button cycles though the possibilities in the following
order:
TONE Front TONE Center
TONE SurrBack TONE Surround
[When not using SURROUND BACK speakers/VSX-839RDS]
TONE Front TONE Center
TONE Surround
3 Use the BASS or TREBLE (+/–) buttons to
adjust the low or high frequencies of each
channel.
A few seconds after you finish adjusting the tone the receiver will
revert to the sound mode it was in at the beginning of the
process.
• The tone can be adjusted in a range of ±6 dB.
• The tone cannot be adjusted in THX and MULTI CH IN
modes.
• When you press the TONE button in DIRECT mode the re-
ceiver switches to STEREO mode and TONE ON appears
in the display. You can now change the TONE setting (note
the receiver is no longer is DIRECT mode).
memo
2
13
To Next Page
Loading...
Need help?
General