96
En
Using Other Functions
Video Select
1 Press RECEIVER (VSX-839RDS only).
2 Press the VIDEO SELECT button (for the
VSX-859RDS on the front panel only) to
cycle through the different possible video
inputs.
The first press shows the video input you are currently using.
After that pressing VIDEO SELECT cycles though the possibili-
ties in the following order:
The OFF setting means that no video signal is output.
After choosing a video input the display on the receiver will
show that input for about 5 seconds and then revert to showing
the sound mode the receiver is in.
The VIDEO SELECT remains set to the input
you chose until you change the audio input.
If you change audio functions the receiver will reset itself to
make the video and audio inputs correspond.
Also, if you switch the power of the receiver OFF when you
turn it back on the video and audio inputs will reset so that they
correspond.
This function allows you to listen to one sound source while you watch a different video source on your TV. The
sound source is set in the normal fashion as is explained on p. 49 & 50. You then alter the video input with the
VIDEO SELECT button.
DVD/LD
VCR1 VCR2
OFF
VIDEO
TV/SAT
()
2
Î
SOURCE
LOUDNESS
INPUT ATT DIGITAL NR FL DIMMER
REMOTE SETUP SYSTEM SETUP SIGNAL SELECT
TV VOL
TV
TVFUNK
ENTER
TUNE
TUNE
D.ACCESS BAND
MENU
CLASS
RETURN
MIDNIGHT DSP STEREO
FUNCTION
ADVANCED STANDARD MUTE
CLEAR AUDIO
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
RECEIVER DIRECT CONTROL
MPX
ST ST
CHANNEL
EFFECT/CH SEL
RECEIVER
TV CONTROL
MASTER VOLUME
VIDEO SELECT
MULTI CONTROL
MULTI CH INPUT
DVD
CD CD-R TUN TVC
RECEIVER
123
456
789
!⁄
0
*‹&
TV
VCR
1
VCR
2
4¢
¶
DISC
+10
TOP MENU
THX
SETUP
/ DTS / MPEG
DISPLAY RF ATT
2
1
2
To Next Page
Loading...
Need help?
General