Pioneer VSX-859RDS User Manual

73
En
Remote Control of Other Components
OPERATION
2.5 – 5 cm
Î
SOURCE
ENTER
LOUDNESS
INPUT ATT DIGITAL NR FL DIMMER
REMOTE SETUP SYSTEM SETUP SIGNAL SELECT
TV VOL
TV
TVFUNK
ENTER
TUNE TUNE
D.ACCESS BAND
GUIDE MENU
CLASS
RETURN
MIDNIGHT DSP STEREO
FUNCTION
ADVANCED STANDARD MUTE
S.MODE CLEAR DTV INFO
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
/ DSP
RECEIVER DIRECT CONTROL
MPX DTV ON / OFF DTV MENU
ST ST
CHANNEL
EFFECT/CH SEL
RECEIVER
TV CONTROL
MASTER VOLUME
DISC
+10
VIDEO SELECT
MULTI CONTROL
MULTI CH INPUT
DVD
CD CD-R TUN TVC
RECEIVER
123 456 789
!⁄
0
*‹&
2
TV
VCR 1
VCR 2
4¢
¶
memo
TOP MENU
Î
SOURCE
LOUDNESS
INPUT ATT DIGITAL NR FL DIMMER
REMOTE SETUP SYSTEM SETUP SIGNAL SELECT
TV VOL
TV
TVFUNK
D.ACCESS BAND
MENU
CLASS
RETURN
MIDNIGHT DSP STEREO AUDIO
ADVANCED STANDARD MUTE
CLEAR DTV INFO
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
RECEIVER DIRECT CONTROL
MPX
CHANNEL
EFFECT/CH SEL
RECEIVER
TV CONTROL
MASTER VOLUME
VIDEO SELECT
MULTI CONTROL
MULTI CH INPUT
DVD
CD CD-R TUN TVC
RECEIVER
123
456
789
!⁄
0
*‹&
TV
VCR
1
VCR
2
4¢
¶
ENTER
TUNE
TUNE
ST ST
4
6
DISC
+10
THX
SETUP
/ DTS / MPEG
DISPLAY RF ATT
2
To cancel LEARNING setup mode
Press SETUP button.
After ten seconds if no commands are entered the remote will
revert to its previous mode.
4 Press the button to be programmed (for
example the 3 [play] button).
The LED flashes rapidly.
5 Point the remote controls at each other,
about 2.5 – 5 centimeters apart, and press
the button on the other remote control for
the operation you want to program (only
the buttons highlighted in the diagram on
the left can be programmed).
1 Point the remote controls toward each other.
2 Press the button on the other remote control corresponding
to the operation you wish to program. The LED on this
receiver’s remote will go out and then blink twice when the
operation is learned. Press the teaching key repeatedly,
varying the distances between the remotes, until you see this
receiver’s remote blink twice, indicating the operation has
been learned.
To program additional operations for the current
component
Repeat steps 2 and 3.
To program operations for another component
Repeat steps 1 through 3.
6 Press RECEIVER to exit the LEARNING
setup mode.
Some commands from other remote controls cannot be
learned, but in most cases the remotes just need to be moved
closer together a farther apart.
The highlighted buttons can
learn new functions.

Pioneer VSX-859RDS Specifications

General

Brand	Pioneer
Model	VSX-859RDS
Category	Receiver
Language	English