8.2
TRANSMISSION
TORQUES / SPECIFICATIONS
Maintain and check/change these items in accordance with the
maintenance schedule in Chapter 2 or during service repairs.
SHIFT LEVER
Removal
1. Pry the shift lever cover using a suitable tool and remove
the screw. Pull knob off the shifter.
2. Refer to Chapter 5 for console cover removal.
3. Disconnect cable from shifter.
4. Remove the clip attaching the gear selector to the machine
frame.
5. Lift the gear shift selector out of mounting bracket and
away from frame.
Installation
1. Perform the steps in reverse order to install the gear shift
selector. (shifter, cable, console, shift knob)
2. Tighten the shift cable nut to specification.
ITEM TORQUE VALUE
Transmission Fill Plugs 40-50 ft. lbs.(54-67 Nm)
Transmission Drain /
Level Plugs
30-45 in. lbs.(0.2-0.3 Nm)
Transmission Case
Screws
23-27 ft. lbs. (31-36 Nm)
Shift Lever Screw 15-20 ft. lbs. (20-27 Nm)
Detent Sleeve Screw 40-45 ft. lbs.(54-61 Nm)
Detent Adjustment Screw 23-27 ft. lbs. (31-36 Nm)
Drain Plugs / Check Plug 30-45 in. lbs.(0.2-0.3 Nm)
Speed Sensor Screw 130-155 in. lbs.(0.9-1.09 Nm)
Position Sensor Screw 25-40 in. lbs.(0.17-0.28 Nm)
Park Flange Screws 130-155 in. lbs.(0.9-1.09 Nm)
Transmission Isolator
Mounting Screws
23-27 ft. lbs. (31-36 Nm)
Transmission Lubricant
Capacity
AGL PN 2873602
24 oz. (710 ml)
Transfer Case Lubricant
Capacity
AGL PN 2873602
14 oz. (414 ml)
Rear Carrier Lubricant
Capacity
ADF PN 2871653
18 oz. (532 ml)
= T
Shift Cable Nut Torque:
130-155 in. lbs. (14.7-17.5 Nm)
To Next Page
Loading...
Need help?
General
