BRAKE INSPECTION
WARNING
Do not apply WD-40® or any petroleum product to brake discs. These types of
products are flammable and may also reduce the friction between the brake
pad and caliper.
1. Check the brake system for fluid leaks.
2. Check the brake pedal for excessive
travel or a spongy feel.
3. Check the friction pads for wear, damage
and looseness.
4. Check brake discs for signs of cracks,
excessive corrosion, warping or other
damage. Clean any grease using an
approved brake cleaner or alcohol.
5. Inspect the brake disc spline and pad
wear surface for excessive wear. Change
pads when worn to 0.030" (0.762 mm).
ABS INSPECTION
1. If the ABS system fails or becomes
defective, the ABS symbol will
illuminate on the Instrument Cluster.
2. If this occurs, decrease vehicle
speed to maximum of 60 km/h.
3. The speed sensors
q
are located in
the front and rear of the vehicle as
shown. To inspect the ABS system,
check that the air gap of all 4 speed
sensors is 0.8 mm (± 0.1)
w
.
CAUTION
Ensure that the ABS sensors are not adjusted outside the appropriate air gap
threshold. The ABS system may function improperly if this occurs.
If more assistance is needed, please contact your Polaris dealer or other
qualified person.
107
MAINTENANCE
To Next Page
Loading...
Need help?
General
