OIL AND FILTER CHANGE
Always change the oil and filters at the intervals outlined in the Periodic
Maintenance Chart section. Always change the oil filter whenever changing oil.
The crankcase drain plug is located on the bottom of the crankcase. Access the
drain plug through the access hole in the skid plate under the crankcase (see
next page).
CAUTION
Always remove all cargo from the cargo box before lifting the box to access
engine components.
Access the oil fill cap, dipstick and filter under the cargo box.
1. Remove all cargo from the cargo box. See Dumping the Cargo Box.
2. Position the vehicle on a level surface.
3. Place the transmission in PARK.
4. Stand clear and pull up on the cargo box release lever. Lift the front of the
cargo box.
5. For maximum clearance in the engine compartment, detach the cargo box
shock from the base of the box.
6. Carefully detach the fuel line and spark plug wires from their retaining clips
on the outlet hose, then loosen the outlet hose clamp and remove the hose
from the clutch cover.
CAUTION
Do not allow debris or other objects to enter the clutch cover.
7. Locate the crankcase drain plug access hole in the skid plate.
8. Clean the area around the crankcase drain plug.
CAUTION
Hot oil can cause burns to skin. Do not allow hot oil to contact skin.
9. Place a drain pan under the engine crankcase and remove the drain plug.
Allow the oil to drain completely.
10.Using an oil filter wrench, turn the filter counter-clockwise to remove it.
11. Using a clean dry cloth, clean the filter sealing surface on the crankcase.
94
MAINTENANCE
To Next Page
Loading...
Need help?
General
