Page 22
English
Program or Cancel Recurring Cleaning Schedules
You can program recurring cleaning schedules using iAquaLink
™
Control. It is still
recommended to remove and clean the lter canister after every cleaning cycle.
1. From the main screen, either select the area titled Next Cleaning Cycle or
go to System Settings and choose Edit Schedule.
2. To program a recurring cleaning schedule, select the day of the week when
you want the cleaner to run.
3. Select a start time to begin the cleaning cycle.
You may choose to display the start time in standard or 24-hour time in system
settings.
4. Press Save to store the cleaning schedule or Cancel to discard.
5. Repeat steps 2-4 to program additional recurring cleaning schedules.
NOTE: Only one programmed cleaning cycle can be scheduled each day. The cleaner will attempt
to perform a cleaning cycle every week at the day/time it is programmed unless the schedule
is changed or canceled. Cleaning cycle duration is determined by the choices made when
setting Cleaning Mode.
6. To delete a recurring cleaning schedule, select the scheduled day and press
Delete Schedule at the bottom of the screen.
7. Press X to leave the Edit Schedule page and return to the main screen.
8. The next scheduled cleaning cycle will display near the top of the main
screen.
In-App Error Messages and Troubleshooting
If an error occurs, the status bar will show a warning symbol and: "Cleaning
Interrupted".
1. Click on the warning symbol to view troubleshooting advice
on how to x the issue.
2. Choose Clear Error if you believe you have xed the problem
and want to re-try. Choose OK if you want to suspend the cleaner in error mode
and work on the troubleshooting x at a later time.
To Next Page
Loading...
Need help?
General
