Page 28
English
6. Separate the lter canister from the lter support (6), as shown in Figure 24.
6
Figure 24. Remove Filter Canister
7. Empty all debris from the lter canister, then rinse the canister, the lter
support and the cleaner using a hose, as shown in Figure 25.
Figure 25. Wash Filter Canister
7
NOTE: Periodically, remove the filter canister and clean thoroughly with soapy water
and a soft bristle brush.
Store the Cleaner When Not in Use
The cleaner must be cleaned regularly using slightly soapy clean water. Do not use
solvents such as trichlorethylene or its equivalent. Rinse the cleaner generously
using clean water. Do not let your cleaner dry in direct sunlight near the pool. The
cleaner should be stored on its caddy so that it dries quickly.
1. Disconnect cleaner from the power source.
2. Starting at the cleaner head, remove all coils and tangles from the cable
(Figure 26). Lay the cable in the sun to loosen any tangling memory.
3. Place the rear wheels on the caddy and position the cleaner vertically on the
caddy base.
To Next Page
Loading...
Need help?
General
