Page 24
English
7 Cleaning, Storage, and
Maintenance
WARNING
To avoid electric shock and other hazards which could result in permanent
injury or death, disconnect (unplug) the cleaner from the power source before
performing any cleaning and maintenance.
Cord Tangling
Tangling can occur more frequently when the cleaner is not attended to after each
cleaning cycle. The tangle-reducing swivel, in addition to proper installation, general
maintenance and the following troubleshooting steps can help to avoid cable
challenges.
IMPORTANT
Cleaner power cable may become tangled if correct
procedure is not followed after each cleaning cycle.
NOTE: For optimal patterning and reduced tangling, the floating cable should enter the water near
the middle of the pool length (Figure 16). Only place enough cable in the water to reach the
farthest point in the pool.
Max
Floating Cable
Length
caddy /
control unit
cleaner
cleaner
Recommended
entry point
Not
Recommended
WARNING: Do not use
an extension cord
Figure 16. Optimal Entry Point in Pool
To Next Page
Loading...
Need help?
General
