GENERAL INFORMATION
1.19
To service the fuel filter:
1. Shut off fuel supply at fuel valve.
2. Remove line clamps at both ends of the filter.
3. Remove fuel lines from filter.
4. Install new filter and clamps onto fuel lines.
5. Turn fuel valve ON.
6. Start engine and inspect for leaks.
OIL TANK
The oil tank cap is located under the seat. The tank
cap is threaded for positive sealing and eases
installation. Periodicallycheck thelevel of the oil tank.
Use Premium 2 Cycle Engine Oil when filling the tank.
CARBURETOR DRAINING
The carburetor float bowl should be drained
periodically to remove moisture or sediment from the
bowl, or before extended periods of storage.
Drain Screw
NOTE: Drain plug is located on the side of the float
bowl.
1. Turn fuel valve to the off position.
2. Place a container beneath the bowl drain spigot or
bowl drain hose.
3. Loosen drain screw and allow fuel in the float bowl
and fuel line to drain completely.
4. Inspect the drained fuel for water or sediment.
5. Tighten drain screw.
6. Turn fuel valve to “ON”.
OFF
RES
ON
Scrambler Fuel Valve
7. Check for fuel leaks.
Enfocus Software - Customer Support
To Next Page
Loading...
Need help?
General
