ENGINE
2.10
TRANSMISSION SERVICE
NOTE: Engine removal is required to service
transmission components. Refer to beginning of
this chapter for removal instructions.
1. Drain the oil from the gear case.
Drain Plug
2. Remove the transmission cover and gasket.
Primary Drive Assy.
Primary Drive
Axle Assy.
Main Axle
3. Remove the washer and the driven clutch gear.
4. Remove the drive axle assembly. Inspect for signs
of wear.
5. Remove the bolt and washer to aid removal of the
bearing and the primary drive assembly.
Transmission Cover
Primary Drive Assy.
Bearing
Bolt
Washer
DRIVE SPROCKET
CIRCLIP
BEARING
OIL SEAL
CIRCLIP
BEARING
DRIVE AXLE
ASSY.
BEARING
MAIN AXLE
WASHER
NUT
WASHER
Drive Shaft (Transmission) Exploded View
Enfocus Software - Customer Support
To Next Page
Loading...
Need help?
General
