LED Indicator Status
Solid red Registration procedure timed out after 5 minutes
Note: When you press a key, the LED lights up in 2 seconds to
i
ndicate that releasing the key deletes the registration. The LED
turns off after 4 more seconds.
Blinking red and green Recovery mode – the repeater locks to a base station or repeater
without repeater mode activated
• Sync: source base station/repeater not found (Manual mode)
• Timeout during Radio fixed Part Number (RPN) allocation
because of a busy base station or repeater
Poly Rove Repeater Status Indicators - Registered
LED Indicator Status
No indicator Powered off
Solid red Error condition; unacceptable Received Signal Strength Indicator
(
RSSI), below -90dBm; critical error
Solid green Ethernet connection available; normal operation with good RSSI,
equal to or better than -75dBm
Blinking green Searching for base stations
Blinking red Ethernet connection not available or handset de/registration
failed
Solid orange Normal operation with pure RSSI, from -90dBm to -75dBm
Poly Rove Multicharger Status Indicators
LED Indicator Status
Red Charging
Green Charged
Access the Home Screen
You can access the Home screen from any other screen on the wireless handset.
Task
» Do one of the following:
• Press the Back softkey until you return to the Home screen.
• Press End .
Power the Phone Off and On
You may want to restart the phone if it malfunctions or to help with troubleshooting.
When you remove the protective plastic tab from the battery, the phone automatically powers on. However, you may want
t
o power on and off the phone at other times.
11
To Next Page
Loading...
Need help?
General
