Polycom CX700 User Manual

User Guide for the Polycom CX700 IP Phone
3 - 6
During a call if you are using the handset, pressing the Volume key adjusts the
handset volume.
During a call, if you are using the headset, pressing the Volume key adjusts
the headset volume.
If you press the Volume key when not in call, the ringer volume is adjusted.
You can also adjust volume by selecting the Settings soft key and the Volume
screen. Refer to Adjusting the Volume on page 2-7.
Placing Calls on Hold
During a call, press the Hold soft key. This will be indicated on the graphic
display by the hold on the graphic display.
Press the Resume soft key again to resume the call.
Hosting Conference Calls
You can initiate a conference call by selecting one or more contacts, by
selecting a contact group, or by selecting a distribution group. You start a
conference call as an initial phone call and then add more contacts. You can
join two calls into one conference through the Merge Calls selection.
Note
As using the Hold feature typically generates music or a beeping tone, avoid putting
a conference call on hold.

Polycom CX700 Specifications

Power

power over Ethernet	IEEE 802.3af Class 2
maximum power consumption	13 Watts

LCD Display

display size	5.7 inches
display type	amorphous-TFT Active-Matrix Transmissive
display resolution	320x240

Audio

frequency response	30 – 20kHz
signal-to-noise ratio	78 dB (@ 1kHz)
dynamic range	>80 dB (@ 1kHz)
total harmonic distortion + noise	<0.08% (@ 1 kHz)

Operating Environment

operating temperature range	-10°C to 40°C
relative humidity	80% max (non-condensing)
operating altitude range	-304.8 meter to 3962.4 meter

Weight and Dimensions

dimensions when not tilted	252.7 x 268.6 x 91.3 mm
dimensions when tilted up	193.2 x 268.6 x 192.1 mm
unit weight	2.1 kg
handset weight	200 g
shipping weight	2 kgs