START-UP PROCEDURE
NOTE:
1. If after 30 seconds, it has not recognized the drone, turn off the controller
and repeat Start-Up procedure.
Before flying, the drone and transmitter must be turned on in sequence
and synchronized.
1. Press the power button for 2 seconds to turn on the drone. The blue lights are
at the front and the yellow are at the back.
2. Place the drone on an even surface in front of you.
3. Turn on the remote control. Push the throttle up and then down and then
release. The remote will beep twice and the back right light will flash.
4. To calibrate GPS, proceed to page 7.
OR
To fly without GPS, proceed to page 8.
6
To Next Page
Loading...
Need help?
General
