Rins171 Issue 6 Page 19
11 PROGRAMMING
11.1 Factory Defaults
The panel is preprogrammed to the factory settings shown below.
Master User code : 1234 (0000-9999)
Limited User code : 5678 (0000-9999)
Engineer code : 9999 (0000-9999)
Bell timer : 20 minutes (programmable 2 to 20 mins)
Entry : 30 seconds (programmable 2 to 255 secs)
Exit : 30 seconds (programmable 2 to 255 secs)
Event log : Engineer reset of log
Downloading access code : 1234
Group reporting : Group1=1, Group2=1, Group3=1
Dial in : Enabled
Zones : End Of Line Resistor
Programmable Outputs : Off
System Option 1 : End Of Line Zone
User Log Reset Disabled
Tone Dial
Internal Sounder Only On Tamper Activation
System Option 2 : 24 Hour Test Dial
Dial In
Spare
Audible PA
System Option 3 : Power Down NVM Reset
Spare
Spare
Spare
Re-sets : Continuous
The zone types are factory set as follows.
Zone Number
1 2 3 4 5 6 7 8
Set A
(QWU\H[LW DFFHVV ,PPHGLDWH LPPHGLDWH LPPHGLDWH LPPHGLDWH LPPHGLDWH LPPHGLDWH
Set B
(QWU\H[LW DFFHVV ,PPHGLDWH LPPHGLDWH LPPHGLDWH LPPHGLDWH LPPHGLDWH LPPHGLDWH
Set C
(QWU\H[LW DFFHVV ,PPHGLDWH LPPHGLDWH LPPHGLDWH LPPHGLDWH LPPHGLDWH LPPHGLDWH
Set D
(QWU\H[LW DFFHVV ,PPHGLDWH LPPHGLDWH LPPHGLDWH LPPHGLDWH LPPHGLDWH LPPHGLDWH
To Next Page
Loading...
Need help?
General
