Pyronix ATLAS 8 User Manual

Page 26
11.17 Digicom Codes
Enter HQWHUVHTXHQFH Enter 1 digit to select the required reporting format.
Examples SIA DTMF
SIA pulse format P1 - 1400 Hz handshake 10pps
SIA pulse format P2- 2300 Hz handshake 20pps
SIA pulse format P3 - 1400 Hz handshake 20pps
Reserved
Reserved
Reserved
11.18 Keyswitch Set Configuration
Enter
Enter digit 0 - 6.
Examples Set A
Set B
Set C
Set D
Reserved
Reserved
Reserved
NOTE:
If a Keyswitch is required to Unset the system, then all the four Set modes must reflect this in the same zone.
11.19 Group Reporting Telephone Allocation
This selection requires all four Groups to be programmed.
Enter
- Group 1 ’Alarm Codes’. Now select where you require the Alarm Codes to be reported to.
No reporting for group
Report to telephone number 1, backup to number 2
Report to telephone number 2 only
Report to both telephone numbers always
After a number has been selected, the next group will be automatically selected.
Group 2 ’User Set/Unset Codes’. Select from the list above where you require User Set/Unset codes to be
reported to.
Group 3 ’Maintenance Codes’. Select from the list above where you require Maintenance codes to be reported to.
Group 4 ’24hr. Test call’. Select from the list above where you require 24hr.Test Call codes to be reported to.
The dual tone sound indicates programming of Group Reporting is now complete.

Pyronix ATLAS 8 Specifications

General

Brand	Pyronix
Model	ATLAS 8
Category	Keypad
Language	English