Matrix User Guide
Page 38 RINS915-2
Step 1: Use the
keys to select the attribute required.
Step 2: To enable an attribute press the key until ON is displayed.
Step 3: To disable an attribute press the key until OFF is displayed.
Repeat steps 1 to 3 until desired attributes have been enabled or disabled
Press to accept.
After allocating User Attributes, the user code maximum use counter must be assigned
Note: Do not remove the master user setting from your main master user code; it can
only be re-instated by the engineer.
User Code Maximum Use Counter
The current setting will be displayed:
Enter the two digits from the following options for desired operation:
= Unlimited User code.
(This code may be used an unlimited number of times. Additionally each time an unlimited code is used,
all the limited use code counters are refreshed, 00 is the factory default for all users)
= One use only code.
(This code is deleted after being used once for either arm or disarm. This code would generally be used
to give to a delivery person who will only use the code once).
to = A number between 2 - 99 represents the amount of times a user code may be used
between uses of an unlimited code.
Press to store the new user code and settings.
To Next Page
Loading...
Need help?
General
