PCX 256 USER MANUAL
Page: 14 RINS867-2
2.3 Arming / Disarming Via The Internal Tag Reader
Once the relevant cards/tags have been programmed into the system (see page ‘Change Codes’
page 22), you may arm and disarm via the internal tag reader.
Please note that ‘Flexi-Arm’ may need to be disabled so that the card will arm the assigned
partitions automatically. This is described on page: 24.
2.3.1 Arming Partitions / Arm Modes via the Internal Tag Reader
1. To arm the system, hold up a valid card/tag until the left UNSET LED illuminates, and remove
the card/tag. The system will begin to arm.
NOTE: The system will only arm depending on what ‘Exit Mode’ is programmed. This would
have been selected by your engineer. For example:
If Timed is selected the system will arm after the exit time has expired.
If Final Door is selected, the system will only arm after the entry/exit door has been opened/closed.
If PTS (Push To Set) is selected, the system will only arm after the Push To Set button has been
pushed.
Power
Alarm
Tamper
Fault
Unset
Tag
To Next Page
Loading...
Need help?
General
