Pyronix STERLING 10 User Manual

Sterling 10 User Manual
RINS415-9 Page: 11
 Press the key to perform the next test: ‘STROBE TEST’ will then be displayed.
 Press the key to perform the next test: ‘BELL TEST’ will then be displayed.
 Press the key to perform the next test: ‘SOUNDERS TEST’ will then be displayed.
 Press the key once more to exit System Test.
ICON Keypad
 Press the Ckey, followed by the key.
 Press the C key to perform the Display Test – all symbols are displayed except for the Fault
symbol.
 Press the Ckey to perform the Strobe Test.
 Press the C key to perform the Bell Test.
 Press the C key to perform the Internal Sounders Test.
 Press the C key to exit the System Test.
3.3 Walk Test Mode
The Walk test function allows each of the Arm Modes to be checked in order to verify that all the
intruder detectors on the alarm system are functioning correctly. When undergoing a walk test the
Engineer or Master User can choose which of the Arm Modes they wish to test. Any zone used in
that Arm Mode will cause a chime at the keypad or extension speaker if they are triggered.
LCD Keypad
 Press the key
 Then the key and scroll to ‘WALK TEST’.
 Press the key to accept.
 Use the key to choose the desired Arm Mode you wish to Walk Test,
 Then press the key.
 Enter the 4-digit Master Code.
After the countdown timer (default 30 seconds) has stopped, the system is armed and ready to be
tested. When the walk test mode is enabled the keypad will display any activated zones. As shown
below:
This enables all the zone configurations to be walk tested individually.
 To exit the walk test enter your 4-digit user code.
A
A
B
C
Y
Z
S
T
U
V
W
X
B
D
E
F
C
G
H
I
D
J
K
L
M
N
O
P
Q
R
Ente
r
SPACE
A
RM
Func
P.A.
Fire
STERLING
SYSTEM ARMED
F DOOR
Ente
r
Func
Ente
r
Func
Ente
r
Func
Ente
r
Func
Ente
r
Func
Ente
r
Func
Ente
r
Func

Pyronix STERLING 10 Specifications

General

Brand	Pyronix
Model	STERLING 10
Category	Control Panel
Language	English