Pyronix STERLING 10 User Manual

Sterling 10 User Manual
Page: 4 RINS415-9
The Entry/Exit timer will start to countdown, after 30 seconds (default) the system will be armed.
If the Sterling hasn’t armed you may have requested for a different exit mode:
If Final Door is programmed:
The exit timer will sound and keep sounding until an Entry/Exit zone is opened and closed. After 7
seconds (default) the system will be armed.
If Push To Arm is programmed:
The exit timer will sound and keep sounding until a Push Button is pressed; once this is pressed the
panel will be armed after 7 seconds.
2.2 Silent Arming The Panel
If you wish to silent arm the Sterling 10, so the entry and exit timer is silent:
 Press the key (on the ICON press the ) then the arm mode you require:
 (for Arm Mode A),
 (for Arm Mode B),
 (for Arm Mode C) or
 (for Arm Mode D).
The diagram below shows how to silent arm the Sterling 10 in Arm Mode A:
A dual tone will be heard on acceptance of the command, and another dual tone will be heard once
the entry time has timed out and the system is armed.
2.3 Arming the panel when the Mains Fails
Under normal operation the panel will indicate a fault condition if the AC supply is disconnected. It will
still be possible to arm and disarm the panel during a mains fail, unless disallowed by the engineer,
and no further action is required. Full functionality of the panel is available during a mains failure.
D
J
K
L
C
G
H
I
B
D
E
F
A
A
B
C
A
RM
A
A
B
C
Y
Z
S
T
U
V
W
X
B
D
E
F
C
G
H
I
D
J
K
L
M
N
O
P
Q
R
Enter
SPACE
A
RM
Func
P.A.
Fire
STERLING
SYSTEM DISARMED

Pyronix STERLING 10 Specifications

General

Brand	Pyronix
Model	STERLING 10
Category	Control Panel
Language	English