- 20 -
5.8. START UNIT SELECTION
Upon selection of start unit, the balance activates with the specified unit for these modes where
change of the unit is possible.
Ability of selecting a given unit depends on the balance status, i.e. if the balance is verified or not.
Procedure:
5.9. CUSTOM UNIT
You can declare two custom units. The custom unit is a result of indication multiplied by a specified
coefficient.
The units are displayed as [u1] – user unit 1, and [u2] – user unit 2.
Procedure for declaration of coefficient for the custom unit:
Custom units are valid for verified balances exclusively.
6. MISCELLANEOUS PARAMETERS
You can set up parameters which influence balance operation. These parameters are to be found in
parameters group P6 OTHER.
Settings modification for particular parameters of this parameter group proceeds likewise as
described in the previous section.
Menu language
Language parameter enables selecting the language of the balance menu descriptions.
To Next Page
Loading...
Need help?
General
