- 86 -
15. COMMUNICATION PROTOCOL
General information
A. A character based communication protocol balance-terminal is designed for establishing
communication between a RADWAG balance and a peripheral device via RS-232C serial
interface.
B. It consists of commands sent from a peripheral device to the balance and responses from
the balance.
C. Responses are sent from the balance on each receipt of a command as a reaction to a
specific command.
D. Commands, forming the communication protocol, enable both, obtaining data on balance
status and influencing balance operation, e.g.: acquiring measurement results from the
balance, zeroing, etc.
15.1. LIST OF COMMANDS
Send stable measurement result in basic measuring unit
Immediately send measurement result in basic measuring unit
Send stable measurement result in current measuring unit
Immediately send measurement result in current measuring unit
Switch on continuous transmission in basic measuring unit
Switch off continuous transmission in basic measuring unit
Switch on continuous transmission in current measuring unit
Switch off continuous transmission in current measuring unit
Set min checkweighing threshold
Set max checkweighing threshold
Give value of min checkweighing threshold
Give value of max checkweighing threshold
Set mass value of a single item
Give balance serial number
Internal adjustment performance
Disable automatic internal adjustment of the balance
Enable automatic internal adjustment of the balance
Give available working modes
Give current working mode
To Next Page
Loading...
Need help?
General
