Install the DirecSteer System
NOTICE
Depending upon the make and model of the machine, the steps
required to complete the installation of the RS1™/SC1™ with
DirecSteer auto-steer system may differ from the instructions
provided in the following procedure.
Prepare for the Installation 17
Recommendations 17
Tools Needed 18
Point of Reference 18
Remove the Steering Wheel 19
Install the Anti-Rotation Bracket 21
Install the DirecSteer Assembly 26
Prepare the DirecSteer Assembly 26
Attach the DirecSteer Assembly to the Steering Column 27
Prepare for the Installation
Before installing the system, park the machine where the ground is level, clean, and dry.
Leave the machine turned off for the duration of the installation process.
During the installation process, follow good safety practices. Be sure to carefully read the
instructions in this manual as you complete the installation process.
Recommendations
Raven Industries recommends the following best practices before installing or operating the
system for the first time, at the start of the season, or when moving the system to another
machine:
17
Chapter 3:
Install the DirecSteer System
To Next Page
Loading...
Need help?
General
