Install SC1™/TC1™ with DirecSteer
5. Thread the antenna onto the mounting base antenna until snug.
Note: Hand-tighten only. Damage resulting from over-tightening is not covered by
the warranty.
6. Connect the power cable (P/N 115-0172-588) to the power port of the 500S™ unit.
7. Route the remaining connection of the power cable into the cab.
Install the 700S™ Receiver
1. Attach the 700S™ receiver to the provided mounting plate.
2. Mount the mounting plate in an unobstructed position on the roof of the cab with
connectors pointing to the rear of the machine.
3. Connect the power cable (P/N 115-0172-589) to the power port of the 700S™ unit.
4. Route the remaining connection of the power cable into the cab.
Connect SC1™ Cabling to DirecSteer
When installing an auto-steer system, the power cables should always be connected to the
battery after all cables have been routed and connected. Two options are available:
l
Implement Ready Power Harness (P/N 115-8000-060/315) with a ISObus IBBC
connector
l
Basic Power Harness (P/N 115-8000-141)
59
To Next Page
Loading...
Need help?
General
