Chapter3
l
Ensure the machine hydraulic filters have been recently changed and there are no
issues with the machine hydraulic system (e.g., pump issues, faulty hydraulic motors,
fine metal deposits in the hydraulic hoses, etc.).
l
Operate each of the machine hydraulic functions (i.e., tilt, fold, center rack, tongue
extension, or other hydraulic valve functions) three times to ensure the machine
hydraulic valve is using fresh oil and debris is flushed from the hydraulic hoses, valves,
and filters.
l
Upon installation of the system, operate the hydraulic functions through the manual
control functions first before operating hydraulic control via the controller/field
computer to ensure the hydraulic system has been installed correctly and air is purged
from the system.
Raven Industries recommends the following best practices when installing the system.
l
Use part numbers to identify the parts.
l
Do not remove the plastic wrap from a part until it is necessary for installation.
l
Do not remove plastic caps from a part until it is necessary for installation.
Tools Needed
The following tools are recommended for installation of the system:
l
Steering wheel puller
l
Standard-sized wrenches
l
Cable ties
l
Set of tools
l
Fish tape (recommended)
Point of Reference
The instructions in this documentation assume that you are standing behind the machine,
looking toward the cab.
18
To Next Page
Loading...
Need help?
General
