Chapter 4: Calibration 29
Master/repeater status
Press the disp button from the software version screen to enter the Master/
Repeater Status screen.
The display shows either:
• r0 to indicate a master instrument, i.e. connected to a transducer
or
• r1 to indicate a repeater instrument, i.e. using data from SeaTalk.
Leaving Intermediate calibration
Press the disp and lock buttons for 2 seconds, to exit Intermediate calibration
and return to normal operation.
4.4 Dealer calibration
Dealer calibration enables the following parameters to be set:
•User calibration on/off.
• Pointer response.
• Heading display response.
• Boat show mode on/off.
Dealer calibration also gives access to the Factory defaults screen. This enables
you to re-apply the factory settings if you want to reset the instrument to a known
operating condition.
To commence Dealer calibration, hold down the
disp and lock buttons together
for approximately 12 seconds to select the Dealer calibration entry screen (see
Dealer calibration
flow chart). Then press the < and > buttons simultaneously, to
start the calibration sequence.
User calibration on/off
Controls access to the User calibration. Access can be either enabled ( UC1 ) or
disabled ( UC0 ), as required.
Use the
< and > buttons to set the value you want.
Note:
If the access to User calibration is disabled, then only the software version screen
will be available in Intermediate calibration; the instrument status screen will not be dis-
played.
81265_1.book Page 29 Monday, December 5, 2005 9:23 AM
To Next Page
Loading...
Need help?
General