Chapter 4: Calibration 31
Boat show mode
Ensure that Boat Show Mode is set to bS0 (disabled). If necessary, use either the
< button or the > button to achieve this.
Factory defaults
You can use this screen to reset the operating parameters to the factory default
values. Use the
< and > buttons to make the required selection.
Note that the selection you make at this screen will be applied when you exit the
screen, so be sure you make the correct selection.
To retain the current values, ensure that the display shows
NO.
If you want to apply the factory defaults, change the display to YES. If you do
this, the values you have set up will be overwritten by the factory defaults when
you leave this screen.
Leaving Dealer calibration
Hold down the disp and lock buttons for 2 seconds, to save your changes, exit
Dealer calibration and resume normal operation.
CAUTION: Do NOT enable Boat Show Mode
Do NOT enable Boat Show Mode. This must be used only for
demonstration purposes.
81265_1.book Page 31 Monday, December 5, 2005 9:23 AM
To Next Page
Loading...
Need help?
General