5.2 Setup and Calibration Operation
To enter Setup
Note: It is not possible to enter setup mode while the Race Timer page
is currently visible. Scroll to a different page in order to enter setup
Press and hold , the first chapter title page is displayed.
To change the active chapter
Press repeatedly until the desired chapter title page is displayed.
At the end of the chapter cycle, the display returns to the first chapter
title page.
If you are currently on a chapter parameter page, you must return to the
chapter title page before you can move to a new chapter.
To access the setup pages
Use to scroll through the pages, returns to the previous page.
5.3 Editing Setup Data
Parameter values may be one of three types:
A user editable numeric value (for example, the Autoleg 1-2
parameter).
To edit a numeric parameter value:
Press . The value data will begin to flash.
Use and to adjust the value.
Press again to set the new value.
A list of options (for example, the Autoleg Start parameter).
To select a parameter option from a list:
Press .The parameter option will begin to flash.
Use and to select the option required.
Press again to set the new option.
A toggle between two alternative options (for example the Auto Leg
Mode parameter).
To toggle between alternate parameter settings:
Press . The setting will toggle between the options.
Maxi Display
18
www.tacktick.com
To Next Page
Loading...
Need help?
General