Introduction
MP150 Protocol Rev. B4 Aug 2019 7
1 Introduction
For many applications, the scanner can be easily configured with the help of the factory distributed
software. In other applications, it would be more useful to integrate the scanner into a larger system or
customize it for specific measuring tasks.
The scanner is programmed via its serial and the Ethernet interface to configure it to specific
measurement applications.
This manual describes the structure of the different commands and their effect on the scanner functions.
With further development of the scanner, deviations from this manual may occur. However, it is the
manufacturer’s intent to maintain forward compatibility with newer versions.
As the scanner rarely checks commands, it is up to the programmer to provide proper command syntax.
Descriptions of the serial and the Ethernet interface are available through computer.
The command interface of the MP150 derives from (is compatible to) the MP50 – this might explain
some structures in the commands.
The structure of this description is as follows:
• It starts with the command structure (section 3),
• followed by the structure of interesting temperature data lines (section 4),
• followed by detailed information for dedicated commands (section 5),
• and ends with a list of all commands (section 7).
To Next Page
Loading...
Need help?
General
