RECORDING BROADCAST STEREO "IV
OR SAP (SECOND AUDIO PROGRAM)
PROG RAMMI NG
Some TV programs are broadcast with stereo audio or SAP
(Second Audio Program).
1. Turn on the TV and tune it to the VCR viewing channel
(either 3, 4, or TV's video input).
2. Insert a tape with safety tab in place.
3. If your VCR viewing channel is 3 or 4, make sure the
VCR indicator appears in the VCR's display panel. If not,
press TV.VCR to turn it on.
4. Use TAPE SPEED on VCR (SPEED on remote) to select a
recording speed. The indicator appears on the TV screen.
S. Select the channel or line input to be recorded.
6. Set the Reception: STEREO/MONO/SAP feature for the type
of audio you want to record. See the section Other
Features for detailed information.
AUDIO
1 Reception: STEREO
2 Tape PLayback: HI-FI
0 Exit
7. Press RECORD to start recording.
8. Press STOP when you are finished.
Video Input Channel Explained
For more information about the TV's
video line input, see "How to Find
Your TV's Video Input Channel" in the
References section of this manual.
Recording audio only will erase
anything that was previously
recorded on the tape.
RECORDING AUDIO ONLY
You can record audio only from another audio source
connected to the AUDIO IN (R and L) jacks on the back or
front of the VCR.
1. Press the INPUT button on the remote to select the line
input (L1 or L2). Select (L1) to record from the back
jacks or (L2) to record from the front jacks. The VCR will
record audio from the audio equipment connected to
the AUDIO IN jacks.
2. Use TAPE SPEED on the VCR (SPEED on the remote) to
select the recording speed.
3. Start audio source playing and press RECORD to begin
recording.
4. Press STOP when you are finished.
Audio Connection
BACK OF VCR
_FOUT
P_NO ltl_ER TA_
BACK OF AMPLIFIER I RECEIVER
35
To Next Page
Loading...
Need help?
General
