CHOOSING A VCR CONNECTION
There are several different ways to connect your VCR,
depending on whether or not you have cable service, if you
have a cable box to see this service, whether some of the cable
channels are scrambled, and so on.
Five different connections are described in this section and
one of them should provide you with a VCR connection that
works.
• TVwith RFjack only
• TV with audio/video jacks
• TV with audio/video jacks and cable box to
unscramble pay channels only
• TV with RF jack and satellite receiver
• TV with audio/video jacks and satellite receiver
If you need to connect additional components not shown in
the diagrams here (and are unsure of how to connect them),
refer to the instruction manual that came with that particular
component.
ADVANTAGES OF AUDIO/VIDEO
CABLE CONNECTIONS
Using a simple coaxial cable connection gives you good
picture quality. If your television has audio/video jacks, I highly
recommend using them to get even better picture quality and
stereo sound when recording and playing back videotapes.
These connections give you more convenient operation by not
having to share the TV's antenna signal.
DON'T FORG ET ABOUT TH E
AUTO TV/VCR FEATU RE
The TV/VCR switch controls whether the picture signal is
coming from the VCR or the TV.
You can set the Auto TV/VCR feature to ON when using only
the IN FROM ANT. and OUT TO TV jacks and OFF when using
the AUDIO/VIDEO output jacks--so your TV signal is not
interrupted when the VCR is turned on. You can change the
setting manually by using the TVoVCR button on the VCR or
the ANTENNA button on the remote.
59
To Next Page
Loading...
Need help?
General
