Redarc BMS1215S2 User Manual

7
1 INTRODUCTION
1.5 Multi-stage Charging Process
The BMS incorporates two different multi-stage charging profi les – Touring
(3-stage) and Storage (5-stage) – which can be selected in the Battery Mode
menu on the Remote Monitor.
Touring Mode
Touring mode is designed for use when ‘on the road’. Touring mode offers a
3-stage charging profi le consisting of Boost, Absorption and Float stages (see
Figure1.4.1). In Touring mode, the house battery is monitored to detect only a
limited number of faults such as short circuit, over current and over voltage.
This allows the BMS to operate correctly even when loads are connected to the
house battery. This mode will always produce an output (unless a fault condition
is detected) and will cycle through the three stages as required to maintain the
house battery as outlined in Figure 1.4.1.
IMPORTANT
Touring mode will achieve its best charge level if a Storage mode charge has
been recently performed.
i
BOOST
ABSORPTION
FLOAT
FloatAbsorptionBoost
Voltage
Current
3 - Stage Charging Process
Figure 1.4.1 - 3-Stage Charging Process

Redarc BMS1215S2 Specifications

General

Brand	Redarc
Model	BMS1215S2
Category	Camera Accessories
Language	English