E2 Lite Precautions for Safety
R20UT3240EJ0300 Rev.3.00 Page 7 of 36
May.15.20
Warnings for AC Power Supply:
Do not repair or remodel the emulator product by yourself in order to prevent danger such as an
electric shock or fire and for the sake of quality assurance. For after-sale services in case of a
mechanical or electrical fault, please contact your local distributor.
Always switch off the Host machine and user system before connecting or disconnecting any cables
or parts. Neglect of this precaution will result in getting an electric shock or will result in the emulator
product or user system emitting smoke or catching fire. Also, the user program under debug will be
destroyed.
Make sure that the connectors on both ends of the user-system interface cable are facing the right
way relative to the user-side connector on the emulator and the connector on the user system,
respectively.
Neglect of this precaution will result in getting an electric shock or will result in the emulator product
or user system emitting smoke or catching fire.
Warning for Modification:
Do not modify the emulator. Personal injury due to electric shock may occur if the emulator is
modified. Modifying the product will void your warranty.
Warning for Installation:
Do not set the emulator in water or areas of high humidity. Make sure that the product does not get
wet. Spilling water or some other liquid into the product may cause un-repairable damage.
Warning for Use temperature:
The emulator is to be used in an environment with a maximum ambient temperature of 35°C.
Care should be taken that this temperature is not exceeded.
To Next Page
Loading...
Need help?
General
