Copying
22
2
Copying from the Bypass Tray
Use the bypass tray to copy onto OHP
transparencies, thick paper, enve-
lopes and copy paper that cannot be
loaded in the paper trays.
Important
Paper of 14.01 inch length, or larg-
er, is likely to jam, crease, or not
feed in properly.
Limitation
You cannot use the duplex func-
tion when copying from the by-
pass tray.
Note
If you do not use standard size
copy paper, or if you use special
paper, you should enter its vertical
and horizontal dimensions. See
p.19 “Placing Custom Size Origi-
nals”. The sizes you can enter are
as follows:
When copying onto OHP transpar-
encies or paper heavier than 105
g/m
2
(about 28 lb.), you need to
specify the paper type. See p.25
“When copying onto special pa-
per” .
The maximum number of sheets
you can load at the same time de-
pends on paper type. The maxi-
mum number of sheets should not
exceed the upper limit.
A Open the bypass tray.
B Push up the paper guide release
lever.
1. Paper guide release lever
Metric
version
• Vertical: 90–216 mm
• Horizontal: 139–600 mm
Inch
version
• Vertical: 3.55"–8.50"
• Horizontal: 5.48"–23.62”
ABU027S
ABU
S.eps
ZFOY
E.eps
To Next Page
Loading...
Need help?
General
