• Depending on the environment, information might not be obtained from the router, and
communication will fail. If this happens, select the “pathmtu” to “off”.
prnlog
Use the “prnlog” command to obtain printer log information.
Print logs display
msh> prnlog
• Display previous print jobs.
msh> prnlog “ID Number”
• Specify the ID number of the displayed print log information to display additional details about
a print job.
• p.204 "Understanding the Displayed Information"
rhpp
Use the “rhpp” command to view and configure RHPP settings.
View settings
msh> rhpp
Changing rhpp port number
msh> rhpp [1024-65535]
• The default is 59100.
Setting timeout
msh> rhpp timeout [30-65535]
• The default is 300 seconds.
• “RHPP” is an abbreviation of “Reliable Host Printing Protocol”, which is a manufacturer-original
printing protocol.
route
Use the “route” command to view and control the routing table.
Specified route information display
msh> route get “destination”
Remote Maintenance by telnet
175
To Next Page
Loading...
Need help?
General
