• p.373 "Configuring IEEE 802.1X"
Parallel Interface
This section describes the user tools in the Parallel Interface menu under Interface Settings.
[Parallel Interface] is displayed when this machine is installed with the IEEE 1284 interface board.
Parallel Timing
Set the timing for the control signal of the parallel interface.
Normally, you do not need to change this setting.
The default setting is [ACK outside].
Parallel Comm. Speed
Set the communication speed for the parallel interface. If the speed is too high, data may not be
transferred smoothly. If this happens, change the setting to [Standard].
The default setting is [High Speed].
Selection Signal Status
Set the level for the select signal of the parallel interface.
The default setting is [High].
Input Prime
Set whether to validate or invalidate the input prime signal upon reception.
Normally, you do not need to change this setting.
The default setting is [Inactive].
Bidirectional Comm.
Set the printer's response mode to a status acquisition request when using a parallel interface. If you
experience problems using another manufacturer's machine, set this to [Off].
The default setting is [On].
When set to [Off], the bidirectional communication function will be disabled, and the printer driver
will not be installed under Windows Auto Detect function.
Signal Control
Specify how error during printing or sending facsimile from the computer is to be dealt with.
Normally, you do not need to change this setting.
The default setting is [Job Acceptance Priority].
• p.18 "Accessing User Tools"
1. System Settings
32
To Next Page
Loading...
Need help?
General
