Panel Key Sound
The beeper (key tone) sounds when a key is pressed.
The default setting is [On].
Warm-up Beeper (copier)
You can have the beeper sound when the machine becomes ready to copy after leaving Energy Saver
mode, or when the power is turned on.
The default setting is [On].
If the Panel Tone setting is [Off], the beeper does not sound, whatever the Warm Up Notice setting.
Copy Count Display (copier)
The copy counter can be set to show the number of copies made (count up) or the number of copies
yet to be made (count down).
The default setting is [Up].
Function Priority
Specify the mode to be displayed immediately after the operation switch is turned on, or when System
Reset mode is turned on.
The default setting is [Copier].
Print Priority
Gives print priority to the mode displayed.
The default setting is [Display mode].
When [Interleave] is selected, the current print job will be interrupted after a maximum of five sheets.
Function Reset Timer
You can set the length of time the machine waits before changing modes when using the multi-access
function.
This is useful if you are making many copies and have to change settings for each copy. If you set a
longer reset period, you can prevent interruption from other functions.
The Function Reset Timer setting is ignored if [Interleave] is set for Print Priority.
The default setting is [Set Time].
When you select [Set Time], enter the time (3-30 seconds, in 1 second increments) using the number
keys.
The default setting for Set Time is 3 seconds.
Display Contrast
You can adjust the brightness of the display.
The default brightness setting is “4” (the halfway/medium setting).
1. System Settings
22
To Next Page
Loading...
Need help?
General
