Network Settings
23
1
Settings Required to Use Scan to Folder Function
This section lists the settings required for sending file.
Ethernet
This section lists the settings required for sending file with Ethernet cable.
For details about how to specify the settings, see "Interface Setting" and "File
Transfer".
Note
! In [Effective Protocol], check that the protocol you want to use is set to [Active].
! [LAN Type] is displayed when the wireless LAN interface board is installed. If
both Ethernet and wireless LAN (IEEE 802.11b) are connected, the selected in-
terface takes precedence.
Reference
p.47 “Interface Settings”
p.53 “File Transfer”
Menu User Tool Setting Requirements
Interface Settings/Network Machine IPv4 Address Necessary
Interface Settings/Network IPv4 Gateway Address Necessary
Interface Settings/Network DNS Configuration As required
Interface Settings/Network DDNS Configuration As required
Interface Settings/Network Domain Name As required
Interface Settings/Network WINS Configuration As required
Interface Settings/Network Effective Protocol Necessary
Interface Settings/Network LAN Type Necessary
Interface Settings/Network Permit SNMPv3 Communictn. As required
Interface Settings/Network Permit SSL/TLS Comm. As required
Interface Settings/Network Host Name As required
File Transfer Default User Name/PW(Send) As required
To Next Page
Loading...
Need help?
General
