2. Getting Started
This chapter describes how to start using this machine.
Guide to Names and Functions of Components
This section introduces the names and functions of the components.
• Do not obstruct the machine's vents. Doing so risks fire caused by overheated internal
components.
Front and left view
1. ADF
Lower the ADF over originals placed on the exposure glass.
If you load a stack of originals in the ADF, the ADF will automatically feed the originals one by one.
The ADF scans both sides of an original one side at a time.
2. Exposure glass
Place originals face down here.
3. Main power switch
To operate the machine, the main power switch must be on. If it is off, turn the switch on.
4. Vents
Prevent overheating.
27
To Next Page
Loading...
Need help?
General
