EasyManuals Logo
Home>Rigol>Test Equipment>DS1104Z-S Plus

Rigol DS1104Z-S Plus User Manual

Rigol DS1104Z-S Plus
268 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #157 background imageLoading...
Page #157 background image
Chapter 6 MATH and Measurement RIGOL
MSO1000Z/DS1000Z User’s Guide 6-43
XY Mode
XY mode is only available when the horizontal time base mode is "XY". In this mode,
two pairs of cursors will appear. You can adjust the cursor positions and the
instrument will automatically calculate the chord length and curvature of the ellipses
corresponding to the crossing points of the two pairs of cursor lines.
Press Cursor Mode "XY" to enable the XY mode cursor measurement function.
The measurement results are displayed at the upper left corner of the screen in the
following mode.
AX: the X value at cursor AX.
AY: the Y value at cursor AY.
BX: the X value at cursor BX.
BY: the Y value at cursor BY.
BX-AX: the horizontal difference between cursors BX and
AX.
BY-AY: the vertical difference between cursors BY and AY.
dX*dY: the product of the horizontal difference between
cursors BX and AX times the vertical difference between
cursors BY and AY.
dX/dY: the quotient of the horizontal difference between
cursors BX and AX divided by the vertical difference
between cursors BY and AY.
absAA: the chord length of the crossing point of cursors
AX and AY relative to the center point. The center point is
defined as the crossing point of the horizontal position
(X-axis) and the vertical position (Y-axis) of two channel labels on the screen as
shown in Figure 6-8.
absAB: the chord length of the crossing point of cursors AX and BY relative to
the center point.
absBA: the chord length of the crossing point of cursors BX and AY relative to
the center point.
absBB: the chord length of the crossing point of cursors BX and BY relative to
the center point.
argAA: the angle between X-axis and absAA. The range is from -180° to +18.
argAB: the angle between X-axis and absAB. The range is from -180° to +180°.
argBA: the angle between X-axis and absBA. The range is from -180° to +180°.
argBB: the angle between X-axis and absBB. The range is from -180° to +180°.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com

Table of Contents

Other manuals for Rigol DS1104Z-S Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rigol DS1104Z-S Plus and is the answer not in the manual?

Rigol DS1104Z-S Plus Specifications

General IconGeneral
BrandRigol
ModelDS1104Z-S Plus
CategoryTest Equipment
LanguageEnglish

Related product manuals