RIGOL Chapter 15 Accessibility Setting
15-2 MSO1000Z/DS1000Z User’s Guide
Remote Interface Configuration
MSO1000Z/DS1000Z provides two remote control interfaces: USB Device (TMC and
SICD static image capture devices share this interface) and LAN. The USB Device
interface takes precedence over the LAN interface. You can press Utility IO
Setting RemoteIO to select the desired communication interface according to
the particular condition.
When the USB Device interface is connected and press Utility IO Setting
USB Device "Computer", the system will select the USB Device interface
automatically as the only valid interface no matter whether the LAN interface is
connected or not. In the RemoteIO menu, the state of the TMC (USB Device) is
"ON", and the state of the LAN is "OFF". The states of the interfaces are not
allowed to be changed.
When only the LAN interface is connected, the system will automatically detect
the LAN interface. In the RemoteIO menu, the state of the LAN is "ON" by
default, and you can press LAN softkey to turn "OFF" or "ON" the LAN interface.
The state of the TMC (USB Device) is "OFF", and it is not allowed to make any
change.
LAN Configuration
Press Utility IO Setting LAN Conf. to turn on the LAN setting interface. You
can view the network connection status and configure the network parameters.
Figure 15-1 LAN Setting Interface
Network Status
Current IP
Config Type
MAC Address
VISA Address
IP Config Type
Status
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
Need help?
General
