Remote Control
DS8000-R series digital oscilloscope can be connected to the PC via the USB,
LAN, or GPIB interface to set up communication and realize remote control
through the PC. The remote control can be realized by using SCPI (Standard
Commands for Programmable Instruments) commands. DS8000-R series digital
oscilloscope supports three ways of remote control: user-defined programming,
PC software (e.g. RIGOL Ultra Sigma), and Web Control.
More Product Information
1. Obtain the device information
Click on the function navigation icon at the lower-left corner of the
screen to open the function navigation. Then click on the "Help" icon
to enter the help menu. Click About to obtain the information of the
instrument, such as the manufacturer, model, serial number, firmware
version number, and hardware version number.
2. Check the option installation status
The instrument is installed with the trial versions of the options before
leaving factory. When you power on the instrument for the first time, the
trial time is about 2,160 minutes. Open the "Help" menu, and then click
Option list to view the options currently installed on the oscilloscope and
their information. Click Option setup to install the option. For detailed
setting methods, refer to descriptions in
DS8000-R User Guide
.
For more information about this instrument, refer to the relevant manuals by
logging in to the official website of RIGOL (www.rigol.com) to download them.
DS8000-R User Guide
: introduces the functions of the instrument and the
operation methods, remote control methods, possible failures and solutions in
using the instrument, the technical specifications, and order information.
DS8000-R Programming Guide
: provides detailed descriptions of SCPI
commands and programming examples of the instrument.
DS8000-R Datasheet
: provides the main features and technical specifications of
the instrument.
To Previous Page
Loading...
Need help?
General
