Connect the active probe:
Take RP7150 (active differential probe) as an example.
1. Connect the probe head to the preamp of the active probe, as shown in
Figure 6.
Figure 6 To Connect the Probe Head to the Preamp of the Active Probe
2. Connect the other end of the preamp to an analog channel input terminal
of the oscilloscope on the front panel, as shown in Figure 7. Note that you
should push the probe to the end to ensure that it is tightly connected.
Figure 7 To Connect the Active Probe
3. Use the probe's auxiliary device to connect the probe head to the circuit
under test. For details about the probes, refer to
RP7000 Series Active
Probe User Guide
.
After connecting the active probe, you can perform probe calibration and offset
voltage adjustment if necessary. For detailed procedures, refer to the "Active
Probe" section in User Guide.
Function Inspection
1. Click on the function navigation icon at the lower-left corner of the
screen to open the function navigation. Then click on the "Storage" icon
to enter the storage and loading setting menu. Click More ā
To Next Page
Loading...
Need help?
General
