WARNING
To avoid electric shock when using the probe, please make sure
that the insulated wire of the probe is in good condition and do
not touch the metallic part of the probe when the probe is
connected to high voltage source.
Probe Compensation
When the probes are used for the first time, you should compensate the probes
to make them match the input channels of the oscilloscope. Non-compensated
or poorly compensated probes may cause measurement inaccuracy or errors.
The probe compensation procedures are as follows:
1. Perform Step 1, 2, 3 and 4 specified in "Function Inspection".
2. Check the displayed waveforms and compare them with the waveforms
shown in Figure 10.
Figure 10 Probe Compensation
3. Use the probe compensation adjustment tool provided in the accessories
to adjust the low-frequency compensation adjustment hole on the probe
until the displayed waveform is consistent with the "Perfectly
compensated" waveform shown in Figure 10.
Common Operation
Click Operation
⚫ Click the menu displayed on the externally connected screen to operate on
the menu.
⚫ Click the function navigation icon at the lower-left corner of the
externally connected screen to enable the function navigation.
⚫ Click the displayed numeric keypad to set the parameters.
⚫ Click the virtual keypad to set the label name, the filename, and other
character strings.
To Next Page
Loading...
Need help?
General
